Symbols; Technical Data; Operating Instructions; Battery Charging - Rockwell ShopSeries RS2317K Manual

CoRdleSS ImpaCt WRenCh

SymBolS

To reduce the risk of injury, user must read
in struction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation
indoor use only
C-Tick approval mark
Fuse
T2A time lag fuse with rated current of 2A
Positive terminal
Negative terminal

teChnICal data

Voltage
No-load speed
impact rate
Max torque
square drive
Battery capacity
Weight

opeRatInG InStRuCtIonS

note: Before using the tool, read the
instruction book carefully.
BeFoRe puttInG Into opeRatIon
a) ChaRGInG the BatteRy (See Fig. a)
ChaRGInG pRoCeduRe
1) Plug the charger into an appropriate outlet. The
Green light (a) will be on.
2) slide the battery pack (3) onto the charger, Green
light (a) will be off and the light (b) will be red to
indicate the charging process has started.
3) After 2 hours, the pack will be fully charged, Red
light (b) will be off, and Green light (a) will be
on.Unplug the charger and remove the battery
pack.
WaRnInG! When battery charge runs out after
continuously use or exposure to direct sunlight
or heat, allow time for the tool to cool down before
re-charging to achieve the full charge.
in a warm environment or after heavy use, the battery
pack may become too hot. Allow time for the battery
to cool down before recharging.
B) BatteRy ChaRGInG
The battery charger supplied is matched to the Li-ion
battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep dis-
charging. When the battery is empty, the machine
is switched off by means of a protective circuit: The
chuck no longer rotates.
in a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
if you want to store the tool for a long time, please
recharge it each 6-10 months to protect the battery
pack.
en
18
0-2300/min
0-3000/min
380N.m
1/2 ˝
3.0Ah Li-ion
3.1kg
7