Network Setting; Wireless Setting - Haier LD42U7000 Owner's Manual

Network Setting

Select the desired network connection mode and correctly set up the parameters.
Press key to enter smart TVand use
Press key to select Network, then press OK.
Press key to select Ethernet setting or Wireless, then press OK.
Ethernet setting
If LAN cable is connected and DHCP (automatically set up) is supported, the Internet Protocol (IP) setting will be
automatically configured.
If you want to manually set up the IP, operate according to the following steps:
1. Press the OK key to select connection so as to automatically obtain an IP address [OFF].
2. Press the keys to select the fields to be changed, and directly enter corresponding parameters, i.e., [IP
address], [subnet mask], [default gateway], [first DNS], and [second DNS], by pressing the number keys.
3. Press the keys to select [Save], and press the OK key to complete the IP address setup.
Network Ethernet settings
Open ethernet
Status
The automatic acquisition IP address
Ethernet setting
IP address
Wireless
subnet mask
Proxy setting
default geteway
first DNS
Wi-Fi Direct
second DNS
Wi-Fi Hotspot
Save

Wireless setting

The system will automatically search for available wireless network access points; press the OK key to enter into the
submenu, set Wi-Fi to [On], press the
key to connect.
If you select an access point with security certification, a password entering interface will appear after you confirms.
Network Wireless
Wi-Fi
Status
TFW
Ethernet setting
CMCC-AUTO
Wireless
TP_Test
Proxy setting
CNCC
Wi-Fi Direct CMCC-AUTO
CMCC-AUTO
Wi-Fi Hotspot
key to select Setting Menu, then press OK.
On
On
0 0 0 0
255 255 255 255
0 0 0 0
0 0 0 0
0 0 0 0
Cancel
Choice Comfirm Back
keys to select an access point you want to connect, and press the OK
On
connect
Choice Comfirm Back
-18-
TV OPERATION