Panasonic SH-ALL1C Owner's Manual page 16

Using WPS (Wi-Fi Protected Setup™)
≥ Do not connect a LAN cable. Doing so will disable the Wi-Fi function.
e.g.,
1
Turn this unit on.
≥ Proceed to the next step after the network indicator changes from blinking in
blue and red to blinking in blue.
– The blinking in blue starts after maximum of approximately 60 seconds. If
the blinking in blue does not start, restore the factory defaults. (l 27)
2
Touch and hold [-WPS] on the unit.
≥ The network indicator (blue) blinks faster.
3
Press and hold the WPS button on the wireless router.
≥ When the connection is established, the network indicator (blue) lights up.
∫ Using the WPS PIN code
After step 2
1
Touch and hold [-WPS] again.
≥ The network indicator (blue) blinks even faster.
2
Enter the PIN code "64428147" into the wireless router.
≥ When the connection is established, the network indicator (blue) lights up.
≥ When canceling the setting in the middle by touching [Í/I], the unit takes a
while to turn off.
– The mode indicator (amber) blinks until the unit is turned off.
≥ Once the unit enters WPS PIN code mode, you cannot set up using the WPS
button. To use the WPS button, turn off and then on the unit, and redo the
network settings.
≥ Depending on a router, other connected devices may temporarily lose their
connection.
≥ For details, refer to the operating instructions of the wireless router.
A compatible wireless router may have the WPS
identifier mark.
- 16 -