Flush Mounting The Gps Receiver - Raymarine RS130 Installation Instructions Manual

4.3 Flush mounting the GPS receiver

30
1. Use the supplied mounting template to mark the 2 fixing holes
and the center hole.
2. Drill the holes using the drill sizes shown on the supplied
template.
3. Screw the 2 fixing studs into the underside of the receiver unit.
4. Place the waterproof gasket into position on the underside of
the receiver.
5. Attach the connector securely to the plug in the base of the unit
and pass the cable through the center hole on the mounting
surface.
6. Carefully position the receiver so that the mounting studs pass
through the holes in the mounting surface.
7. Secure the receiver to the mounting surface using the two thumb
nuts (these should be hand-tight only).
Rail mounting the GPS receiver
1. Obtain a suitable rail mounting bracket from your dealer. It must
have a 1 inch 14 TPI thread.
2. Secure the rail mounting bracket to the GPS receiver.
3. Secure the bracket to a suitable rail.
4. Route the cable along the rail and secure with cable ties.
D12047-1
RS130 GPS Receiver – Installation instructions