Setup
(Port) Forwarding
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
Cisco RV320/RV325 Administration Guide
To add or edit a service to the table:
To add a service, click Add in the Port Range Forwarding table.
To edit a service, select the row and click Edit.
The fields are open for modification.
Configure the following:
•
Select a Service from the drop-down menu. (If a service is not listed, you can
modify the list by following the instructions in the
Service Name
•
Enter the IP Address of the server.
•
Select the Interface.
•
Select the Status. Check the box to enable the service. Uncheck the box to
disable the service.
Click Save.
Adding or Editing a Service Name
To add or edit an entry on the Service list:
Click Service Management. If the web browser displays a warning about the
pop-up window, allow the blocked content.
To add a service, click Add in the Service Management table.
To edit a service, select the row and click Edit.
The fields are open for modification. If the web browser displays a warning about
the pop-up window, allow the blocked content.
You can have up to 30 services in the list:
•
Service Name—Short description.
•
Protocol—Required protocol. Refer to the documentation for the service
that you are hosting.
•
Port Range—Range of port numbers reserved for this service.
section.)
3
Adding or Editing a
35