Troubleshooting Guide; General Operation - Panasonic DMP-MST60 Operating Instructions Manual

Troubleshooting guide

Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
Do you have the latest firmware installed?
Panasonic is constantly improving the unit's
firmware to ensure that our customers are
enjoying the latest technology. (
The following do not indicate a problem with
this unit:
– Image disturbance during search.
Unit does not respond to remote
∫
control or the unit's button.
Disconnect the AC adaptor, wait 1 minute, then
reconnect the AC adaptor.
Reference

General operation

To return to the factory preset.
Select "Yes" in "Default Settings" in the Setup
menu. (
To return all settings to the factory preset.
Reset the unit as follows:
1 Turn the unit on.
12)
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– INFO LED and POWER LED start to flash,
3 Press [1] (right) repeatedly on the remote
control until "08FIN" is displayed on the
screen.
4 Press and hold [OK] for more than 5 seconds.
The remote control does not work properly.
Change the batteries in the remote control.
[Refer to "Accessories" in "Operating
Instructions (Essential Information)"]
The remote control and this unit are using
different codes. Turn on this unit by using the
standby/on switch on this unit, and check
"Remote control ", which is displayed on the
screen when you press a button on the
remote control. Press and hold [OK] and the
displayed number (" ") for more than
5 seconds.
The TV tuner mode is not displayed when the
TV is switched on.
This phenomenon may occur, depending on the
TV setting, when "Quick Start" is set to "On".
Depending on the TV, this phenomenon may
be prevented by reconnecting the HDMI cable
to a different HDMI input terminal or by
changing the HDMI auto connection setting.
- 29 -
27)
and "00RET" is displayed on the screen.