Reference; Led Indicators; Messages - Panasonic DMP-MST60 Operating Instructions Manual

LED indicators

Reference

Error states are indicated by the INFO LED.
Confirm the following items in correspondence to
the state of INFO LED of this unit.
≥ If the state of the INFO LED does not change
after performing the operations in the table
below, contact your local Panasonic dealer.
POWER INFO

A INFO LED
INFO LED
state
The remote control and this unit
are using different codes.
Turn on this unit by using the
standby/on switch on this unit,
and check "Remote control ",
Flashes
which is displayed on the screen
6 times
when you press a button on the
remote control.
Press and hold [OK] and the
displayed number (" ") for more
than 5 seconds.
The USB device is drawing too
much power. Please disconnect
or remove the USB device from
Lights up
the unit.
The USB device may be
incompatible.
Reference
Description

Messages

Check the following when message are displayed
on the screen.
Cannot play.
An attempt was made to play back
incompatible content.
Cannot play on this unit.
You tried to play a non-compatible image.
$ This operation is not available.
Some operations are unsupported by the unit.
IP address is not set.
The "IP Address" in "IP Address / DNS
Settings" is "---. ---. ---. ---". Set the "IP
Address", "Subnet Mask", and "Gateway
Address". (Select the automatic address
acquisition if necessary.)
The wireless access point currently has a low
network security setting. It is recommended to
change to a higher setting.
Set a stronger network security level referring
to the wireless router operating instructions.
- 28 -