Completing Installation - Viking Designer Series Installation Manual

INSTALLING CUSTOM FRONT (DFC MODELS ONLY)
1. Prepare custom front panel and handle. (See information on p. 4 for details/dimensions.)
2. Placed prepared custom front panel on the ledge of the unit. (See Illustration #1).
3. Attach to unit by placing two (2) #10 x 1/2" screws in the lower most holes and screwing through the pilot holes on
the overlay. (See illustration #2). Loosen screws and center panel if needed. Retighten lower most screws after
adjusting.
I I l l l l u u s s t t a a t t i i o o n n 1 1
4. Secure the overlay panel by using the remaining seventeen (17) #10 x 1/2 screws. (See illustration #3).
5. Install the storage compartment cover with two (2) #8 x 3/8" wafer head screws. (See Illustration #4).
I I l l l l u u s s t t r r a a t t i i o o n n 3 3
I I l l l l u u s s t t r r a a t t i i o o n n 2 2
Ledge for panel
I I l l l l u u s s t t r r a a t t i i o o n n 4 4
6

COMPLETING INSTALLATION

WARNING: PERSONAL INJURY HAZARD
When moving or lifting the compactor, use a glove to protect
and cushion you hand. Failure to follow these instructions may
result in personal injury.
1. Move compactor to final position. Turn key to STOP/LOCK position.
2. Place level on top of compactor. Check that compactor is level from front to back and side to side. Adjust the four
leveling feet until compactor is level. Allow at least 1/4" (.6 cm) clearance between the compactor top and
countertop.
3. Install anti-tip bracket. See instructions below
4. Read use and care manual to fully understand your new compactor. Keep all literature in a safe place for future
reference.
I I n n s s t t a a l l l l i i n n g g t t h h e e A A n n t t i i - - T T i i p p B B r r a a c c k k e e t t : :
1. After leveling legs, measure from the floor to the top of the compactor base plate from the backside. See Figure 1.
This "A" measurement will determine the height needed for the bracket.
2. Measure from the floor to the bottom of the bracket with the measurement "A" + 1/8" (0.3 cm) and mark the two
holes with a marker or pencil. Place the two screws into the bracket and tighten firmly to wall. See Figure 2. Note:
Place the screws into a wall stud for better stability.
3. Plug power supply cord into grounded outlet. Move compactor into final position, making sure the bracket fits
inside the opening in the rear of the unit.
F F i i g g u u r r e e 1 1
CAUTION: FLOOR DAMAGE
Do not allow the rear frame of the compactor
to touch the floor when lifting or rolling.
Doing so could damage floor covering.
F F i i g g u u r r e e 2 2
7