Wall Mounting - Sharp Aquos LC-32D33X Operation Manual

Appendix

Wall Mounting

Mark the monitor's outline by placing tape at four points on the wall where the LCD-TV's four
1
corners' will lie when it is installed.
• When you mark the monitor's outline on the wall, make sure that the vertical and horizontal lines are made accurate
to the TV's dimension.
• Use adhesive tape that will not leave permanent marks.
Make diagonal lines from the four corners and mark their intersecting point.
2
• Diagonally stretch string and mark the intersecting point in a way that no permanent marks will be left on the wall.
Mount the bracket on the wall by positioning the bracket's mark that indicates the display's
3
centre onto the intersecting point.
• The following measurement fi gures are rough estimates. The fi gures differ according to the location where you attach
the TV.
1 Remove the screws from the stand.
4
2 Attach the bracket to the LCD-TV.
3 When adjusting the bracket's angle, adjust it before installing the TV on the wall.
• The adjusting angles of AN-37AG5 are 0°, 5°, 10°, 15° and 20°.
4 Lift the TV, remove it from the stand and attach it to the bracket.
• Attach the TV by aligning the monitor's four corners with the wall markings.
• When you adjust the TV's angle, make sure to remove the monitor from the wall.
Remove the tape and the string from the wall.
5
NOTE
• The above description is for reference. Please mount the TV in a way which properly suits the location.
LC-32D33X
When using wall mount bracket AN-37AG5
On the wall bracket of
AN-37AG5, there is a
letter 'A' indicating the
center point of the TV
monitor.
74
32D33X_en_j.indd 74 32D33X_en_j.indd 74
200
7 7 6
wall markings
2 9 4
313
*Every time the attaching point is moved,
this figure changes by 50 mm.
tape
dimensional markings
175
2008-3-12 8:13:08 2008-3-12 8:13:08