Installation; Language; Channel Installation - Magnavox 55MV314X Owner's Manual

Installation

1
Press Z (Home) and use H I J K to select Setup then press
OK.
2
Use H I to select Installation, then press OK.
Picture

Language

Sound Channels
Features Preferences
Installation Network
Software Restore default settings
USB
3
Adjust the following items.
Language
1
Use H I to select Language, then press OK.
Picture Language
Sound Channels
Features Preferences
Installation Network
Software Restore default settings
USB
2
Use H I to select English, Español or Français, then press OK.
Note(s)
If you need the English menu instead of the Spanish or French menu's, press Z (Home).
●
Use H I J K to select Configuración or Configuration, then press OK.
Use H I to select Instalación or Installation, then press OK.
Use H I to select Idioma or Langue, then press OK.
Use H I to select English, then press OK.
Press Z (Home) to exit the Home menu.
English
Autoprogram
Location
Network settings a
Reset AV settings
English
Français
Español

Channel installation

Be sure the RF cable is correctly connected to this Unit and you are
registered with your Cable TV provider when you Install Cable channels.
Autoprogram
If you switch wires (e.g. between antenna and CATV) or if you move the
unit to a different area after the initial setting, or if you restore the DTV
channels you deleted, it is recommended to use AutoProgram to perform
a new channel search.
You need to select the signal type in Installation mode before you
perform AutoProgram.
1
Use H I to Select Channels, then press OK.
2
Use H I to Select Autoprogram, then press OK.
If you run Autoprogram when you have Locked Channels, a
●
Message appears asking to enter your PIN. Enter your PIN in order
to Complete the Installation. You need to set the Channel Lock
again after the Installation.
If Pin is forgotten go to Change PIN. L p. 29
3
Press OK to Select Start now.
When the Scanning and Memorizing of Available Channels is
●
Completed, the Lowest Memorized Channel will be Displayed.
4
Follow the On-screen Instructions to Complete the Installation.
System searching. Please wait...
Digital channels found:
Analog channels found:
Auto programming may take more than 20 minutes to
complete.
Stop
Note(s)
After setting Autoprogram, using CH + / – skips unavailable channels automatically.
●
If you are not receiving a signal from your Cable service, contact the Cable provider.
●
If you press B or OK during Autoprogram, the setup of TV channels will be cancelled.
●
Even if Autoprogram is completed, the channel setting will be lost if the AC power cord
●
is unplugged before the unit goes into Standby mode by pressing B.
The PIN Code will be required Once you set a PIN code in the Child and Ratings Lock.
●
L p. 28
If you want to change your PIN code, follow the instruction for Change PIN. L p. 29
●
30 .
0
0
Continued on next page.
English