Procedure; User Calibration On/Off - Raymarine ST60+ Owner's Handbook Manual

Chapter 4: Calibration

Procedure

To carry out Dealer calibration:
1. Hold down the
select the Dealer calibration entry page (see
2. Press the track and reset buttons together, to start Dealer calibration.
3. Referring to the Dealer calibration diagram below, use the
to each screen in turn, and set the appropriate values as described below.
To enter Dealer calibration, hold down
and
for approximately 12 seconds
Entry
screen
track
and
User cal
on/off
Self test entry
Dealer calibration

User calibration on/off

Press the track or reset button to toggle the User calibration either ON or
OFF as required.
If at any time, you want to access the software version and serial number, you need
Note:
to set User calibration ON .
and
reset
Response
track
buttons together for approximately 12 seconds, to
Dealer calibration
reset
diagram).
button to cycle
Battery voltage
Default reset
45
D6479-1