Filling The Clean Water Tank - Hoover CleanJet Instruction Manual

FILLING THE CLEAN WATER TANK

The clean water tank holds the water and cleaning
solution.
IMPORTANT: Always turn the cleaner off and
disconnect from the electrical outlet before
filling the clean water tank.
!
!
IMPORTANT:When filling
the clean water tank, do not
exceed the max fill line.
Press the clean water tank release latch
3
and remove from the cleaner.
Add the required amount of cleaning
1
(approx. 40ml per 1L of water)
Do not use any high-foaming solutions as
an excessive amount of foam impairs the
functioning of the shampooer.
Open the screw cap on the bottom of
4
the tank.
- 5 -
Mix the solution with warm water.
2
(Max. temperature - 40ºC)
Do not use boiling water.
Preferably use distilled water to
prevent calcification.
Pour the solution into the clean water
5
Replace the cap and return the clean
water tank to the cleaner.