Hoover CleanJet Instruction Manual page 4

PREPARING YOUR CLEANER
This appliance should be switched off and
1
disconnected form the power supply before
preparing the cleaner.
Remove the accessories from the
2
following:
Cleaner body
Cloth adaptor plate*
Cloth*
To fold the handle press the handle
4
release button and fold to the storage
position.
(*Certain models only)
Raise the handle to the upright position
3
until it locks in place.
Once the handle has been lowered lift
5
the carry handle to allow the cleaner to
be carried from room to room.
- 4 -
BEFORE CLEANING CARPET
• Vacuum carpet thoroughly.
Use a vacuum cleaner with a power
head for best results.
• Test for colourfastness
• Move the furniture
Test for colourfastness - Wet a white absorbent
cloth with the solution. In a small, hidden area
of your carpet, gently rub the surface with the
dampened cloth.
Wait ten minutes and check for colour removal or
bleed with a white paper towel.
If your carpet has more than one colour, check
all colours.
When cleaning an entire room, move furniture
out of the area to be cleaned. If the furniture is
too heavy to move, place aluminium foil or wax
paper under legs. This will prevent wood
finishes from staining your carpet. Pin up
furniture skirts and curtains.
NOTE: Do not over saturate your carpet.
!
!
IMPORTANT: This cleaner
should not be used to dry
vacuum the carpet.