Recording/Playback With Midi Switch Off - Korg SDD-200 Owner's Manual

iviuuc
A RECORDING/PLAYBACK
WITH MIDI SWITCH OFF
1. BASIC SETTING
Foot switch or drum machine
_L Turn off SDD-2000 and all equipment to be con-
nected. Make connections referring to the Rear
Panel/Connections section of this manual.
• If you will be using the sampling mode, make con
nections from a drum machine trigger output or foot
switch to the SDD-2000 rear panel TRIG input jack
2. After completing connections, turn on the power on
the SDD-2000 and other equipment (amp, keyboard,
drum machine, etc.)
! Adjust input level so that the HEADROOM indicator
+ 6dB LED illuminates occasionally on the highest
signal peaks.
2. RECORDING/PLAYBACK
PROCEDURE
J_ Press the SEQ (sequencer) or SAMPLING switch to
select the mode to be used.
• At this point, parameter values (frequency, intensity,
effect) set in the delay mode are carried over un
changed into the selected sequencer or samplina
mode.
Press SEQ or SAMPLING switch.
LED lights on switch that is pressed.
OATA/TlMeimTT
WHITE
□
PROGRAMMER
Indicates that
recording is now possible
Flashing indicates time mode
(x4 mode shown here)
2 The display appears as shown here.
• The time mode switches back and forth between xi
and x4 each time the TIME x 4 switch is pressed.
Select the time mode according to your require
ments for high frequency response and length of
recording time. The *4 mode enables delay times of
up to 4368ms. Maximum delay time in the *1 mode
is 1092ms, but high range response is better.