Program Write Procedure - Korg SDD-200 Owner's Manual

PffOGNO 1| 0ATA/T1M€(m«)
PROGRAMMER
-This cct lights up
B Editing
Program contents can be edited by the following
method.
QD Press the PROG/PARA switch so that the LED goes
out »r
(2 Press the switch for the parameter that you want to
change.
• When you press one of the parameter switches (such
as FREQ, INTENSITY, EFFECT, FEEDBACK, TIME)
its LED will illuminate and the value of that
parameter will be shown on the display.
Use the INCREMENTAL CONTROL knob to adjust
the value of the selected parameter.
• The time mode switches back and forth between x 4
and x 1 each time the TIME x 4 switch Is pressed.
• A dot at the left side of the data display lights up
when a value has been changed. The dot goes out if
you return to the previously stored value.
NOTE:
•The edit will be cancelled if you change to a different
program number and then return to the edited pro
gram number. j
• Programs remain as edited if the power is turned off
and then turned on again.
}. PROGRAM WRITE PROCEDURE
OTCCAU
*OG/MM
PI
LJ ;...
^ROGR
**K)GNO 11 OATA/TlMEtms) ! -
Flashing
Press WRITE switch.
Jj Select a program that is similar to the effect that you
want to create.
2 Edit to obtain the desired effect.
3 Press the WRITE switch. The displayed program
number will flash on and off.
A Select the program number under which you wish to
save your effect. The program number can be
selected by the INCREMENTAL CONTROL knob, by
a PROG UP foot switch, or by MIDI program change
data.
Si Press the WRITE switch again to complete the pro
gram write procedure.