Switching The Power On/Off; Switching The Power On - MUTOH Blizzard User Manual

3.1 SWITCHING THE POWER ON/OFF

Caution
B ON
EFORE POWERING
TUBES ARE CONNECTED TO THE WASTE BOTTLE

3.1.1 Switching the power ON

Power ON the printer according to the procedure below:
Step 1 : Press the [POWER] key of the operation panel.
The POWER lamp of the operation panel will light (green).
Step 2 : The printer will start initial start-up operations.
Step 3 : The printer will ask if you want to perform a WiperClean. When it is the first start up in a few
hours, it is highly recommended to press [YES] – [F2] and to clean the wipers with Mutoh Mild
Solvent or Mutoh Eco-Solvent Ultra cleaning in order to remove all ink and to make the wipers
more elastic.
,
THE PRINTER MAKE SURE THAT THE WASTE BOTTLE IS INSTALLED AND THAT THE WASTE
.
32
User's Guide Blizzard
Chapter 3: Basics
AP-75260 – Rev. 2.1 – 15/01/08