Basics; Switching The Power On/Off - MUTOH Rockhopper 3 Extreme Operation Instructions Manual

3.1 SWITCHING THE POWER ON/OFF

Caution
Before powering ON the unit, make sure the waste bottle is installed.
3.1.1 Switching the power ON
3.1.2 Turning the power ON
Turn the power of the unit ON according to following procedure.
Press the [POWER] key of the operation panel, to turn the unit ON.
Step 1 :
The POWER lamp of the operation panel will light (green).
The unit will start initial start-up operations.
Step 2 :
After finishing initial start-up operations, the unit will enter the normal
Step 3 :
operating condition.
3.1.3 Turning the power OFF
Turn the power of the unit OFF according to the following procedure.
Verify the following regarding the operational condition of the unit.
Step 1 :
There is no printing operation being performed.
The operation panel is in a normal status.
Press the [POWER] key of the operation panel to turn the unit OFF.
Step 2 :
Following message is displayed for 3 seconds on the operation panel.
Step 3 :
The product will perform the power OFF operation.
Step 4 :
Following message is displayed on the operation panel.
All lamps and the LCD of the operation panel will turn OFF.
The product will automatically turn the power OFF after performing a tubing flush.
Operation Instructions Rockhopper 3 Extreme
23
CHAPTER 3 : BASICS

3 BASICS

AP-77150 – Rev. 1.1 – 05/04/07