Connecting Ethernet Cable - Dell SonicPoint-N Dual Radio Getting Started Manual

Connecting Ethernet Cable

To connect the SonicPoint to your network:
1. Using CAT5, CAT5e, or CAT6 cabling, connect the "lan"
port of the SonicPoint to the interface you previously
configured on the Dell SonicWALL security appliance.
2. Optionally, SonicPoints may be powered by using the Dell
SonicWALL 802.11at PoE line injector (sold separately), or
by using a third-party 802.3at compliant PoE switch.
Note: If using a PoE switch/injector to power the SonicPoint,
ensure that the switch/injector is 802.11at compliant
and rated to deliver at least 25.5 watts. Always read
and comply with instructions and warnings provided
with the PoE before connecting the device to your
SonicPoint.
Connecting Ethernet Cable | 23