Table of Contents
Advertisement
PROFIBUS DP Slave Communication Card CMC-PD01
3
Installation
3.1
Connecting CMC-PD01 to VFD-C2000
1.
Switch off the power of VFD-C2000.
2.
Open the front cover of VFD-C2000.
3.
Place the insulation spacer into the positioning pin and aim the two holes on the PCB at the
positioning pin. Press the pin to clip the holes with the PCB (see Figure 3.1-1).
4.
Screw up after the PCB is clipped with the holes (see Figure 3.1-2).
3.2
Disconnecting CMC-PD01 from VFD-C2000
1.
Remove the two screws (see Figure 3.2-1).
2.
Twist open the card clip and insert the slot type screwdriver to the hollow to separate the PCB
from the card clip (see Figure 3.2-2).
3.
Twist open the other card clip to remove the PCB (see Figure 3.2-3).
4
Figure 3.1-1
Figure 3.2-1
Figure 3.2-3
Figure 3.1-2
Figure 3.2-2
DVP-PLC Operation Manual
Advertisement
Table of Contents
