Ground Cable - Dell Virtual Edge Platform 4600 Setup Manual

• Two-post rail kit, no tools required
• One or two AC PSUs, depending on the configuration
• Five AC normal fan units
• One or two country- and region-specific AC power cords, depending on the
configuration
• Ground lug kit (included in the accessories box)
• VEP4600 Setup Guide
• Safety and Regulatory Information
• Warranty and Support Information
1 Place the container on a clean, flat surface and cut all straps securing the container.
2 Open the container.
3 Carefully remove the platform from the container and place it on a secure and clean
surface.
4 Remove all packing material.
5 Inspect the product and accessories for damage.

Ground cable

To attach a ground cable to the switch, use the included two M3 ground lug bracket screws.
The switch ships with the M3 ground lug bracket screws attached.
NOTE: For AC-powered platforms, although the third conductor of the AC power
cord provides a ground path, Dell EMC recommends grounding your platform with a
dedicated ground wire.
The ground cable is not included. To properly ground the platform, Dell EMC recommends a
one- or two-hole lug, M3 hole size. The ground lug must be a UL-recognized, crimp-type lug.
CAUTION: Grounding conductors
conductors.
NOTE: Coat the one-hole lug with an anti-oxidant compound before crimping. Also,
bring any unplated mating surfaces to a shiny finish and coat with an anti-oxidant
before mating. Plated mating surfaces must be clean and free from contamination.
NOTE: The rack installation ears are not suitable for grounding.
must be made of copper. Do not use aluminum
VEP4600 installation 11