C.
Verify outside length of weight tube measures 9.5 inches. See Figure 5.
9.5"
Weight
Bearing Sleeve
Tube
Figure 5
D.
Using a 1/8" Allen wrench secure tube in place with set screws located on both sides of frame. See Figure 5.
E.
Repeat steps 5A- 5D for opposite weight tube.
6. Verify proper operation.
7. Anchor machine to fl oor.
A.
Securely anchor machine to the fl oor using the anchor holes provided in each machine.
NOTE: Cybex is not responsible for the actual anchoring of equipment. Consult with a professional contractor.
NOTE: Use fasteners having a minimum of 500 lbs. tensile capacity (3/8" grade 2 bolts or better).
NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or frame not in contact with
surface using fl at washers.
Cybex Plate Loaded 16110 Leg Press Owner's Manual
Frame
Bearing Sleeve
Set Screw (2)
Page 9