Table of Contents
Advertisement
Damaged Parts
Materials damaged in shipment should not be returned for credit. Shipping damages are the responsibility of the carrier
(UPS, Federal Express, trucking companies, etc.)
Apparent Damage - Upon receipt of your shipment, check all items carefully. Any damage seen with a visual check must
be noted on the freight bill and signed by the carrier's agent. Failure to do so will result in the carriers refusal to honor your
damage claim. The carrier will provide you with the required forms for fi ling such claims.
Concealed Damage - Damage not seen with a visual check upon receipt of a shipment but notices later must be reported
to the carrier as soon as possible. Upon discovery of the damage, a written or phone request to the carrier asking them to
perform an inspection of the materials must be made within ten days of the delivery date. Keep all shipping containers and
packing materials as they will be needed in the inspection process. The carrier will provide you with an inspection report
and the necessary forms for fi ling a concealed damage claim. Concealed damage claim is the carrier's responsibility.
Tools Required
• 1/8" Allen wrench
• 5/16" Allen wrench
• 3/4" Wrench
NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that there is appropriate clearance
around each machine to allow for safe use and passage.
NOTE: Refer to chapter 6 for reference diagrams.
1. Read and understand all instructions thoroughly before starting any of the procedures listed on this
instruction sheet.
2. Verify you have received the appropriate confi guration.
A.
Verify that you received the correct color machine that you ordered.
B.
Verify you received the appropriate owner's manual.
C.
Verify you received the warranty sheet.
3. Move to desired location.
A.
Note the diminsions of the machine:
Machine Weight: 443 lbs. Size: 64 W" x 83" L x 54" H
Machine Weight: 201 kg. Size: 163 cm W x 211 cm L x 137 cm H
NOTE: Keep all shipping packages near area of installation.
B.
Remove hardware pack and verify contents. See Figure 1.
C.
Carefully remove foam and shrink wrap securing weight
bar and weight tubes.
D.
Carefully remove each (standard) cone-shaped shipping support using a 3/4" socket or wrench.
E.
Carefully place rubber feet (supplied with machine) on each foot of the frame.
Cybex Plate Loaded 16110 Leg Press Owner's Manual
4 - Assembly
A
C
B
A. Locknut .500-13 (6), HN784000
B. BHSCS .500-13 X 1.25 (6),JC780420
C. Split, Lockwasher .375 (6), HS348300
Figure 1
Page 7
Advertisement
Table of Contents
