Chevrolet Corvette 2014 Owner's Manual page 59

temperature. If necessary, move
the vehicle to a heated indoor
area to operate the top.
If the top has recently been
cycled repeatedly or left in an
intermediate state, it will be
temporarily disabled. A DIC
message displays. Normal
operation will be restored within
10 minutes after the system has
cooled.
If the vehicle battery is low, the
power top operation may be
disabled. Try to start the vehicle.
A DIC message displays.
If the battery has recently been
reconnected or if the vehicle has
been jump started, the top may
not operate until the power
windows have been indexed.
Complete the power window
indexing procedure. See Power
Windows on page 2-22.
See Convertible Top Messages on
page 5-32.
Other features may be affected
while operating the convertible top:
The trunk can only be opened
with the key until the convertible
top is completely opened or
closed.
Do not try to start the vehicle
while opening the top with the
RKE transmitter. A DIC message
may display. Release both
buttons and wait a few seconds
before starting the vehicle
normally.
The passive door unlock feature
may not operate properly while
using the RKE transmitter to
open the convertible top.
The windows cannot close while
the top is moving.
If the vehicle battery has been
disconnected and reconnected, the
fuses were pulled or replaced, or a
jump start was performed, the TOP
NOT SECURE message may
Keys, Doors, and Windows
display. Press and hold
open/close the top until this
message is cleared.
See Convertible Top Messages on
page 5-32.
Partial Top Cycling
If the convertible top operation is
stopped before completion, the top
will temporarily hold its position.
If the ignition is in ACC/
ACCESSORY or ON/RUN/START,
the top will be held for up to
five minutes. If the vehicle is moving
or off, the amount of time will vary
from a few seconds to about a
minute.
Beeps and DIC messages will be
displayed before the top will move.
When this occurs, immediately finish
the convertible top operation by
pressing the button again until it
completes.
If the top cannot be secured, keep
clear of the top components. In
some conditions the top may move
quickly.
2-31
to