Chevrolet Corvette 2014 Owner's Manual page 34

2-6 Keys, Doors, and Windows
The vehicle can be reprogrammed
so that lost or stolen transmitters no
longer work. Each vehicle can have
up to eight transmitters programmed
to it.
Programming with a Recognized
Transmitter
A new transmitter can be
programmed to the vehicle when
there is one recognized transmitter.
1. The vehicle must be off and both
the recognized and new
transmitters must be with you.
2. Remove key base from the
recognized RKE transmitter.
3. Place the recognized transmitter
in the cupholder.
4. Insert the vehicle key into the
key cylinder above the license
plate.
5. Open the hatch/trunk.
6. Turn the key five times within
10 seconds.
7. The DIC displays READY FOR
REMOTE # 3 or 4, up to 8.
8. Place the new transmitter in the
steering column transmitter
pocket with the buttons facing up
and the base toward the opening
facing the passenger side.
9. Press the ENGINE START/
STOP button.
10. The DIC displays READY FOR
REMOTE # 4 or 5, up to 8.
11. Press on each newly
programmed transmitter to
complete the process.
12. To program additional
transmitters, repeat
Steps 8 11. Press and hold the
ENGINE START/STOP button
for 12 seconds if programming
is complete.
Return the key base back into
the RKE transmitter.
Programming without a
Recognized Transmitter
If there are no currently recognized
transmitters available, follow this
procedure to program up to eight
transmitters. This feature is not
available in Canada. This procedure
will take approximately 30 minutes
to complete. The vehicle must be off
and all transmitters to be
programmed must be present.
1. The vehicle must be off.
2. Remove the key from the
transmitter and insert the vehicle
key into the key cylinder above
the license plate.
3. Open the hatch/trunk.