Programming The Portion Control; Stop Button - Cornelius QUEST ELITE 2000 Installation Manual

PROGRAMMING THE PORTION CONTROL

S B
TOP UTTON
© 2010-2012, IMI Cornelius Inc.
If the dispenser has optional portion controls, they have been pre-programmed
from the factory to pour 7, 12, and 16 ounce drinks. The "extra large" (pitcher
icon) size has also been pre-programmed to pour 16 ounces. To change the
pour sizes, please perform the following procedure.
Step
Simultaneously, press and hold Small and Extra Large buttons on the Portion
1 Control Module until the Refill light starts blinking. Release the buttons. The
blinking Refill light indicates the programming mode is active. See Figure 9.
Place a cup under the dispense nozzle and push the selected size button (small,
2 medium, large, or extra large). Hold the button in until the cup fills to the desired
portion, then release the button. Repeat the procedure for the remaining sizes.
After programming all the drink sizes, press and release the Stop button to return
3
the Portion Control to the operational mode. The blinking REFILL light goes off.
In the future, to change the portion size of the drinks, the individual sizes can be
4 adjusted by performing Step 2. It is not necessary to reprogram every size. Addi-
tionally, the portion control has full memory retention in case of a power failure.
To pour a drink without using a pre-programmed portion control size, simply
push and hold the Stop button. Release when the glass is full.
- 15 -
Quest Elite 2000 Installation Manual
Table 1
Action
Figure 9. Control Panel
Publication Number: 620048922INS