To Openthe Door Manually; Careof Youropener - Craftsman 139.3043 Owner's Manual

Garage door opener with assurelink connectivity
Hide thumbs Also See for 139.3043:
Table of Contents

Advertisement

Available languages

Available languages

To Openthe Door Manually
DISCONNECT THE TROLLEY
The door should be fully closed if
possible. Pull down on the
emergency releasehandle (so that
the trolley releasearm snaps into a
vertical position) and lift the door
manually. The lockout feature
prevents the trolley from
reconnecting automatically, and the
door can be raised and lowered
manually as often as necessary.
TO RE-CONNECT THE TROLLEY
Pull the emergency releasehandle
toward the opener at an angle so
that the trolley releasearm is
horizontal, The trolley will
reconnect on the next UP or DOWN
operation, either manually or by
using the door control or remote.
Trolley
Trolley --
ReleaseArm
(In Manual
Disconnect
Position)
Lockout position
(Manual disconnect)
Trolley
Trolley
ReleaseArm
(Down and Back)
TOreconnect
To prevent possible SERIOUSINJURYor DEATHfrom a falling
garage door:
• If possible, use emergency releasehandle to disengage
trolley ONLYwhen garage door is CLOSED.Weak or broken
springs or unbalanceddoor could result in an open door
falling rapidly and/or unexpectedly.
• NEVERuse emergency releasehandle unless garage doorway
is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope knot
becomes untied, you could fall.
Careof YourOpener
MAINTENANCE SCHEDULE
Everymonth
• Manually operate door. If it is unbalancedor binding, call a
trained door systems technician.
• Checkto be sure door opens and closes fully. Adjust if
necessary (refer to Adjustment section).
• Repeatthe safety reversetest. Make any necessary
adjustments (refer to Adjustment section).
Everyyear
• Oil door rollers, bearings and hinges. The garage door opener
does not require additional lubrication. Do not grease the door
tracks.
• Test the battery and consider replacing the battery to ensure
the garage door opener will operate during an electrical power
outage, see page 31 to test the battery backup.
THE REMOTECONTROLBATTERY
To prevent possible SERIOUSINJURYor DEATH:
• NEVERallow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• ReplaceONLYwith 3V2032 coin batteries.
• DONOT recharge, disassemble, heat above 212° F (100° C)
or incinerate.
The lithium battery should produce
power for up to 5 years.
To replace battery, use the visor clip
or screwdriver blade to pry open the
case as shown. Insert battery positive
side up (+). Replacethe battery with
only 3V2032 coin cell batteries.
Dispose of old battery properly.
Pry open the case first in the
middle (1), then at each side
(2 and 3) with the visor clip.
NOTICE: T o comply with FCC and/or Industry Canada(IC) rules, adjustment or modifications of this
transceiver are prohibited. THERE ARE NO USER SERVICEABLEPARTS. Any changes or
modifications not expressly approved by the party responsiblefor compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCCrules and IC RSS-210. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interferencereceived, including interferencethat may cause undesired operation.
This ClassB digital apparatuscomplies with CanadianICES-003.
AVIS :Les
r_gles de la FCC et/ou d'lndustrie
Canada (IC) interdisent
tout ajuetement
ou toute
modification
de ce r6cepteur.
IL N'EXISTE AUCUNE PIECE SUSCEPTIBLE D'ETRE ENTRETENUE PAR
L'UTILISATEUR.
Tout changement
ou route modification
non express6ment
approuv6
par la partie
responsable
de la conformit6
peut avoir pour r6sultat
d'annuler
I'autorit6
de I'utilisateur
de faire
fonctionner
1'6quipement.
Cet appareil est conforme
aux dispositions
de la partie 15 du r_glement de la FCC et de la norme IC
RSS-210.
Son utilisation
est assujettie aux deux conditions
suivantes
: (1) ce dispositif
ne peut
causer des interf@ences
nuisibles,
et (2) ce dispositif
doit accepter toute interf@ence
reque, y
compris
une interf@ence pouvant causer un fonctionnement
non souhait6.
Cet appareil num@ique de la classe B est conforme _ la norme NMB-O03 du Canada.
36

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents