Care And Maintenance - Pride Mobility Go-Go ULTRA X Owner's Manual

X . C A R E A N D M A I N T E N A N C E
Your Travel Scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability
to perform the maintenance listed below, you may schedule inspection and maintenance at your authorized Pride
Provider. The following areas require periodic inspection and/or care and maintenance.
TIRE PRESSURE
! If equipped with pneumatic tires, always maintain a proper 30-35 psi (2-2.4 bar) tire pressure.
WARNING! It is important that 30-35 psi (2-2.4 bar) tire pressure be maintained in pneumatic
tires at all times. Do not underinflate or overinflate your tires. Low pressure may result in
loss of control, and overinflated tires may burst. Failure to maintain 30-35 psi (2-2.4 bar)
tire pressure in pneumatic tires at all times may result in tire and/or wheel failure.
! Regularly inspect your Travel Scooter's tires for signs of wear.
WHEEL REPLACEMENT
If your Travel Scooter is equipped with pneumatic tires and you have a flat tire, you can have the tube replaced. If
your Travel Scooter is equipped with a solid tire insert, either the solid insert or the entire wheel must be replaced
depending on model. Contact your authorized Pride Provider for information regarding replacement wheels for
your Travel Scooter.
WARNING! Completely deflate pneumatic tires before dismantling the rim or attempting
repair.
WARNING! When changing a tire, remove only the center lug nut, then remove the wheel.
If any further disassembly is required, deflate the tire completely or it may explode.
EXTERIOR SURFACES
Bumpers, tires, and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the Travel Scooter's vinyl seat or tire
tread. They will become dangerously slippery.
CLEANING AND DISINFECTION
! Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your Travel Scooter.
Avoid using products that may scratch the surface of your Travel Scooter.
! If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or
premature deterioration of upholstery and/or Travel Scooter finishes.
BATTERY TERMINAL CONNECTIONS
Make certain that the terminal connections remain tight and are not corroded.
Go-Go Ultra X www.pridemobility.com
35