Table of Contents
Advertisement
CONTROL
the default is Light On.
TURBO
In Cool or Heat mode, pressing this button can activate or deactivate this function. When this function is on, its
symbol will be displayed. Any change of either mode or fan speed will make this function canceled automatically.
BLOW
BlOW On and BLOW Off can be set by pressing this button. In Cool and Dehumidifying modes, press this button
to activate this function and then "BLOW" will be displayed. After that, it can be canceled by repressing this button.
After powered on, the default is Blow Off. If the ON/OFF button is operated or the unit is switched to the Cool or
Dehumidifying mode, it will keep its original status. When the unit is turned off, Only Blow Off is available. Under
Auto, Fan or Heat mode, this function is unavailable.
The preset temperature can be decreased by pressing this button. If the button is pressed down for more than 2
seconds, the temperature will be decreased quickly until it is released, with
mode, the temperature adjustment is unavailable.
The preset temperature can be increased by pressing this button. If the button is pressed down for more than 2
seconds, the temperature will be increased quickly until it is released, with
mode, the temperature adjustment is unavailable. The setting range is 16-30
TEMP
It can be decided by pressing this button which temperature will be displayed, indoor set temperature, or indoor
ambient temperature. When the indoor unit is powered on, the indoor set temperature will be displayed, while if the
status is changed to
, the indoor ambient temperature will be displayed. However, the indoor set temperature will be
displayed again when the controller receives other remote controls signals. Without setting this function, the default is
the indoor set temperature.
SWING UP/DOWN (
The swing angle which circularly changes as below can be selected by pressing this button:
This kind of remoter controller is universal. And the three swing statuses of
If the swing function is deactivated when the air guide louver is swing up and down, it will stop at the current
position.
AIR (
)
AIR ON or Air OFF can be selected by pressing this button.
TIMER ON
"ON" will be displayed and blink for 5 seconds by pressing this button, and soon adjust the time by pressing
within 5 seconds. Each press will make the time increased or decreased by 1 minute. If the button is pressed down
and then is the value on the ten's place. Once Timer ON has been set already, it can be canceled by repressing it. Before
the setting, please adjust the CLOCK to the current actual time.
TIMER OFF
TIME OFF can be activated by pressing this button, with "OFF" blinking. The method of setting is the same as
that for TIMER ON.
HEALTH (
)
This function can be activated or deactivated by pressing this button. After the unit is turned on, the default is
HEALTH ON.
I FEEL
This function can be activated by pressing this button and canceled by another press. When this function is on, the
I FEEL information will be sent out in 200ms after each operation on the controller and the remote controller will send
the temperature information to the main controller every 10 minutes.
3.2.2 Guide for General Operation
1) After powered on, press ON/OFF and then the unit will start to run. (Note: when powered off, the guide louver
of the main unit will close automatically).
2) Press MODE to select the desired running mode.
3) Press
or
to set the desired temperature (it is unnecessary to set the temperature under the AUTO mode.)
4) Press FAN to set the fan speed, AUTO, LOW, MID, or HIGH.
5) Press
to select the swing angle.
28
)
(
) displayed al the time. Under Auto
(
) displayed all the time. Under Auto
or 61-86
are the same as that of
.
or
Advertisement
Table of Contents
