Mounting The Access Point On A Support - Cisco AIR-LAP1310G Mounting Instructions

Mounting the Access Point on a Support

This warning applies to outdoor installations:
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
To attach the access point to a support, follow these steps:
Mount the housing bracket to the mounting bracket by sliding the hang pins on the housing bracket into
Step 1
the hang pin slots on the mounting bracket. The connectors should face downward (See
Figure 13
1
Secure the housing bracket to the support bracket with four hex bolts and flat washers.
Step 2
Note
Roughly position the integrated antenna by pointing the flat face of the access point toward the site of
Step 3
the remote access point.
After aligning the antenna, tighten all mounting bolts to 6 to 10 ft-lbs.
Step 4
78-17634-01
Mounting the Access Point to the Support
1 5
0
1 5
I S
T H
E
S I D
U P
Hex bolt with serrated flange and washer (4 locations)
If you are using the integrated antenna, loosely tighten the U bolts so you can adjust the access
point horizontally for antenna positioning.
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
1
1
Mounting the Access Point
Figure 13).
31