Liftgate Scuff Plate; Front Seat Belt Retractor - Dodge 2000 DURANGO Service Manual

23 - 56 BODY
REMOVAL AND INSTALLATION (Continued)

LIFTGATE SCUFF PLATE

REMOVAL
(1) Remove screws attaching cargo tie downs to
liftgate scuff plate (Fig. 86).
(2) Grasp scuff plate and lift upward to disengage
spring clips.
(3) Separate scuff plate from liftgate opening.
Fig. 86 Liftgate Scuff Plate
1 – CARGO TIE DOWN
2 – LIFT GATE SCUFF PLATE
INSTALLATION
(1) Position scuff plate in liftgate opening.
(2) Press scuff plate to engage spring clips.
(3) Install screws attaching cargo tie downs to lift-
gate scuff plate (Fig. 86).

FRONT SEAT BELT RETRACTOR

CAUTION: Inspect the condition of the shoulder
belt and lap belt. Replace any belt that is cut,
frayed, torn, or damaged in any way. Also, replace
the shoulder belt if the retractor is either damaged
or inoperative.
REMOVAL
(1) Detach the turning loop cover from the upper
anchor bolt.
(2) Remove upper anchor bolt (Fig. 87).
(3) Remove B-pillar trim.
(4) Remove the retractor anchor bolt.
(5) Disconnect retractor wire harness connector.
(6) Remove screws attaching web guide to B-pillar.
(7) Remove front seat side shield, if equipped.
(8) Remove front seat belt anchor bolt (Fig. 88).
(9) Separate retractor from vehicle.
Fig. 87 Front Seat Belt Retractor
1 – TURNING LOOP
2 – ADJUSTER
3 – UPPER B-PILLAR TRIM
4 – B-PILLAR
5 – ANTI-RATTLE CUP
6 – ANCHOR BOLT
7 – LOWER B-PILLAR TRIM
8 – RETRACTOR
Fig. 88 Front Seat Belt Anchor
1 – ANCHOR BOLT
2 – BUCKET SEAT
INSTALLATION
(1) Position retractor in the vehicle.
(2) Install retractor anchor bolt. Tighten to 39 N·m
(29 ft. lbs.) torque.
(3) Connect retractor wire harness connector.
(4) Install web guide to B-pillar.
(5) Install B-pillar trim.
(6) Install upper anchor bolt. Tighten to 39 N·m
(29 ft. lbs.) torque.
DN