GE Double Oven Self-Cleaning Gas Ranges Owner's Manual page 27

Troubleshooting tips ... Before you call for service
Problem Possible Cause
Oven light does not Light bulb is loose or defective.
work
Pad operating light is broken.
Oven will not The temperature is too high to set a
self-clean self-clean operation.
Oven controls improperly set.
Excessive smoking Excessive soil or grease..
during clean cycle
Excessive smoking Food too close to burner element.
during broiling
Oven door will not Oven too hot.
open after a clean
cycle
Oven not clean after Oven controls improperly set.
a clean cycle
Oven was heavily soiled.
The self-clean cycle has been selected
"DOOR " flashes in
but the door is not closed.
the display
LOCKED light is on The oven door is locked because
when you want to the temperature inside the oven
cook has not dropped below the locking
temperature.
"F— and a number You have a function error code.
or letter" flash in
the display
If the function code repeats.
Display goes blank A fuse in your home may be blown or the
circuit breaker tripped.
The clock is turned off.
Oven is in Sabbath Mode.
Power outage, Power outage or surge
clock flashes
"Burning" or "oily" This is normal in a new oven and will
odor emitting from disappear in time.
the vent
Strong odor An odor from the oven insulation is
normal for the first few times the oven
is used.
My oven door glass No. The inner oven glass is coated with
appears to be a heat barrier to reflect the heat back
"tinted" or have a into the oven to prevent heat loss and
"rainbow" color. Is keep the outer door cool while baking.
this defective?
"Shut Door" flashes The oven door has been left open.
in the display
Cooking mode Door left open after "Shut Door"
shuts off when flashed in display.
door left open
49-85213-3
What To Do
Tighten or replace bulb.
Call for service.
Allow the oven to cool and reset the controls.
See the Cleaning the Oven section.
Press the Cancel/Off pad. Open the windows to rid
the room of smoke. Wait until the LOCKED light goes
off. Wipe up the excess soil and reset the clean cycle.
Lower the rack position of the food.
Allow the oven to cool below locking temperature.
See the Cleaning the Oven section.
Clean up heavy spillovers before starting the clean
again or for a longer period of time.
Close the oven door.
Press the Cancel/Off pad. Allow the oven to cool.
Press the Cancel/Off pad. Allow the oven to cool for one
hour. Put the oven back into operation.
seconds and then reconnect power. If the function
error code repeats, call for service.
See the Special features section.
See the Special Features section.
reset it by pressing the Cancel/Off pad, setting the
clock and resetting any cooking function.
To speed the process, set a self-clean cycle for a
section. This is temporary.
This is temporary and will go away after several uses
or a self-clean cycle.
see this tint or rainbow color.
Close door and normal mode will resume.
Close door and normal mode will resume.
27