Electronic Oven Control; Display; Start; Cancel Off - KitchenAid KEBC167 Use & Care Manual

ELECTRONIC OVEN CONTROL

1
1. Oven Display Symbol
2. Heat Settings
3. Oven Display
4. Start/Stop Time
5. Number Pads
6. Control Lock

Display

When power is first supplied to the appliance, everything on the
displays will light up for 5 seconds. Then, "PF" will appear on the
oven display and a time of day will appear on the Time of Day
display. Press CANCEL OFF to clear the oven display.
If "PF" appears at any other time, a power failure has occurred.
Press CANCEL OFF and reset the clock if needed.
Oven Display
When the oven is in use, this display shows the oven
temperature, heat source(s) and start time.
In addition, during Timed Cooking, this display shows a vertical
bar and time countdown and the stop time (if entered).
If "Err" appears on the oven display, an invalid pad was pressed.
Press CANCEL OFF and retry your entry.
When the oven is not in use, this display is blank.
Time of Day, Timer Display
This display shows the time of day or Timer countdown.
The START pad begins all oven functions except the Timer,
Control Lock and Sabbath Mode. If not pressed within 5 seconds
after pressing a pad, "START?" will appear on the oven display as
a reminder. If not pressed within 4 or 5 minutes after pressing a
pad, the oven display will return to inactive mode (blank) and the
programmed function will be canceled.
6
2 3
9 10
7. Time of Day/Timer Display

8. Start

9. Oven Settings
10. EASYCONVECT™ Conversion
11. Timed Cooking
Start
4 5 6
1 2 3
CONTROL
LOCK
4 5 6
8 9
7
CONVECT 0
OVEN
FULL F
LIGHT
MEAL
SURFACE LIGHT
KitchenAid Superba
11 12
The CANCEL OFF pad stops the oven functions except for the
Clock, Timer, Control Lock and Sabbath Mode. The cooling fan
may continue to operate even after an oven function has been
canceled, depending on the oven temperature.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven, Timer and Timed Cooking
are off.
1. Press CLOCK SET/START.
2. Press the number pads to set the time of day.
3. Press CLOCK SET/START or START.
To Remove/Return Time of Day from Display: Press and hold
CLOCK SET/START for 5 seconds. Repeat to redisplay. The time
should not have to be reset.
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated
Function has been entered
Three tones
Invalid pad press
Four tones
End of cycle
Reminder, repeating each minute after the end-of-cycle tones
7 8
13 14 15 16
12. Convect Full Meal
13. Oven Light

14. Clock

15. Minute Timer

16. Cancel Off

Cancel Off
Clock

Tones