Table of Contents
Advertisement
J ) F_PANEL (2x7 pins jumper)
HD (IDE Hard Disk Active LED) Pin 1: LED anode(+)
SPK (Speaker Connector)
RST (Reset Switch)
PD+/PD_G/PD_Y(Power LED) Pin 1: LED anode(+)
PW (Soft Power Connector)
Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis
front panel to the front panel jumper according to the pin assignment above.
G) Battery
2
1
Open: Normal Operation
Open: Normal Operation
+
14
13
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Close: Reset Hardware System
Pin 2: LED cathode(-)
Pin 3: LED cathode(-)
Close: Power On/Off
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer's instructions.
2 5
Hardware Installation Process
Advertisement
Table of Contents
