3Com NETBuilder SI Using Manual page 85

Multiple destinations connect
with a dial pool.
Start here
Unbind each ISDN path from its port:
SETDefault !3.1 -PATH DialCONTrol = DYNamic
SETDefault !3.2 -PATH DialCONTrol = DYNamic
SETDefault !4 -PATH DialCONTrol = DYNamic
Syntax: SETDefault !<path> -PATH DialCONTrol = DYNamic | STAtic
Create a virtual port for each destination using their SysCallerIDs:
ADD !V1 -PORT VirtualPort SCID "Saratoga"
ADD !V2 -PORT VirtualPort SCID "Berkeley"
ADD !V3 -PORT VirtualPort SCID "LosAltos"
Syntax: ADD !<port> -PORT VirtualPort SCID "<SysCallerID>"
Set the normal bandwidth for each virtual port that differs from the
default 64 Kbps:
SETDefault !V1 -PORT NORMalBandwidth = 128
SETDefault !V3 -PORT NORMalBandwidth = 128
SETDefault !<port> -PORT NORMalBandwidth = <kbps> (>=0)
Syntax:
Enable Multilink PPP on ports !V1 and !V3 to achieve 128 Kbps:
SETDefault !V1 -PPP MlpCONTrol = Enabled
SETDefault !V3 -PPP MlpCONTrol = Enabled
Syntax: SETDefault !<port> -PPP MlpCONTrol = Enabled | Disabled
Create the dial number list for each virtual port. For 128 Kbps connections: if you have
one phone number for your destination, enter the number twice with a letter after the second
entry. If you have two numbers, enter each phone number:
ADD !V1 -PORT DialNoList "1-408-555-1000" Baud = 64 Type = Bri
ADD !V1 -PORT DialNoList "1-408-555-1000a" Baud = 64 Type = Bri
ADD !V2 -PORT DialNoList "1-510-555-1234" Baud = 64 Type = Bri
ADD !V3 -PORT DialNoList "1-415-555-2000" Baud = 64 Type = Bri
ADD !V3 -PORT DialNoList "1-415-555-2001" Baud = 64 Type = Bri
Note: The baud rate set in the dial number list matches the baud rate of the lines available
to the port. The normal bandwidth determines how many lines of size 64 Kbps to use.
ADD !<port> -PORT DialNoList "<phone no>" [Baud = <rate> (1.2–16000)]
Syntax:
[Type = Modem | Bri | Sw56] [Pos = <number>]
Done
85