Command History Substitution - 3Com NETBuilder SI Using Manual

158 A C: S
PPENDIX YNTAX
Command History
Substitution
Table 19 History Substitution Option Syntax
Syntax
!!
!<n>
! –<n>
!<string>
!?<string>
^<string1>
^<string1>^<string2>
C
ONVENTIONS
The bridge/router "remembers" the 10 most recent commands you
entered. To display a list of these commands, enter:
SHow History
To repeat any of the commands displayed, use the event designator,
which is represented by an exclamation point (
history substitution option syntax.
Description
Repeats the previous command.
Repeats the command line numbered n.
Repeats the command whose number is the current command number minus n. The
current command number is printed on the screen preceding the prompt. For
example, if the current command is 100 and n is 2, command number 98 is repeated.
Repeats the most recent command that starts with string. The SHow History command
might display the following commands:
166 setdefault !1 -path control = enabled
167 show -path configuration
168 show history
169 set screenlength = 23
170 setdefault -bridge control = bridge
171 show statistics ?
If you enter !setd at the prompt, the most recent occurrence of the SETDefault
command (setd -br cont = b, number 170) is executed.
Repeats the most recent command containing string.
Repeats the most recent command that contains string1. If string2 is specified, it
substitutes for string1 in that command. For example, if you entered this SETDefault
command with a typing mistake:
seed welcomestring = "You are talking to the 3Com NETBuilder"
To repeat the command with the correct spelling of SETD, you do not need to reenter
the entire command. Enter the following command:
^seed^setd
The following command is displayed and executed:
setd welcomestring = "You are talking to the 3Com NETBuilder"
). Table 19 describes
!