Personal Safety; Environmental Safety; Cleaning And Disposal; Symbols - Stanley FatMax Instruction Manual

90577318 FME600K Oscillating Tool Manual.qxd:??????-00 Cir Saw book
1. No children or pregnant women should enter the work area where the paint

PERSONAL SAFETY

sanding is being done until all clean up is completed.
2. A dust mask or respirator should be worn by all persons entering the work area.
The filter should be replaced daily or whenever the wearer has difficulty breathing.
See your local hardware store for the proper N.I.O.S.H. approved dust mask.
3. NO EATING, DRINKING or SMOKING should be done in the work area to prevent
ingesting contaminated paint particles. Workers should wash and clean up
BEFORE eating, drinking or smoking. Articles of food, drink, or smoking should not
be left in the work area where dust would settle on them.
1. Paint should be removed in such a manner as to minimize the amount of dust

ENVIRONMENTAL SAFETY

generated.
2. Areas where paint removal is occurring should be sealed with plastic sheeting of 4
mils thickness.
3. Sanding should be done in a manner to reduce tracking of paint dust outside the
work area.
1. All surfaces in the work area should be vacuumed and thoroughly cleaned daily for

CLEANING AND DISPOSAL

the duration of the sanding project. Vacuum filter bags should be changed frequently.
2. Plastic drop cloths should be gathered up and disposed of along with any dust
chips or other removal debris. They should be placed in sealed refuse receptacles
and disposed of through regular trash pick-up procedures. During clean up,
children and pregnant women should be kept away from the immediate work area.
3. All toys, washable furniture and utensils used by children should be washed
thoroughly before being used again.
• The label on your tool may include the following symbols. The symbols and their

Symbols

definitions are as follows:
V..................volts
Hz................hertz
min ..............minutes
............direct current
................Class I Construction
(grounded)
................Class II Construction
• When using an extension cord, be sure to use one heavy enough to carry the current
(double insulated)
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The table shows the correct size to use depending
on cord length and nameplate ampere rating. If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the cord.
120V
Volts
240V
More
Ampere Rating
Than
0
6
10
12
Minimum Gauge for Cord Sets
0-25 26-50
Total Length of Cord in Feet
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50 51-100
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more American Wire Gauge
Than
- 6 18 16
- 10 18 16
- 12 16 16
- 16 14 12
A ..................amperes
W..................watts
................alternating current
n o ................no load speed
..................earthing terminal
................safety alert symbol
opm ..............oscillations per minute
51-100 101-150
101-200 201-300
16 14
14 12
14 12
Not Recommended
5
12/12/11 10:07 AM