Personal Safety - Stanley SRR1200 Original Instructions Manual

ENGLISH
(Original instructions)
c. Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools. Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in
accordance with these instructions, taking into
account the working conditions and the work to be
performed. Use of the power tool for operations different
from those intended could result in a hazardous
situation.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
ADDITIONAL SAFETY INSTRUCTIONS FOR
ROUTERS
• Hold power tool by insulated gripping surfaces,
because the cutter may contact its own cord. Cutting
a "live" wire may make exposed metal parts of the power
tool "live" and shock the operator.
• Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the work by your hand or against the body leaves it
unstable and may lead to loss of control.
• Only use router bits with a shank diameter equal to the
size of the collet installed in the tool.
• Only use router bits suitable for the no-load speed of the
tool.
• Never use router bits with a diameter exceeding the
maximum diameter specified in the technical data
section.
• Do not use the tool in an inverted position.
• Do not attempt to use the tool in a stationary mode.
6
• Take special care when routing MDF or surfaces coated
with lead-based paint.
• Wear a dust mask specifically designed for protection
against lead paint dust and fumes and ensure that
persons within or entering the work area are also
protected.
• Do not let children or pregnant women enter the work
area.
• Do not eat, drink or smoke in the work area.
• Dispose of dust particles and any other debris safely.
• Always wear a dust mask.
• This appliance is not intended for use by young or infirm
persons without supervision. children must be supervised
to ensure they do not play with the appliance.

PERSONAL SAFETY

• No children or pregnant women should enter the work
rea where the paint sanding is being done until all
cleanup is completed.
• A dust mask or respirator should be worn by all persons
entering the work area. The filter should be replaced
daily or whenever the wearer has difficulty breathing.
Note: only those dust masks suitable for working with
lead paint dust and fumes should be used. Ordinary
painting masks do not offer this protection. See your
local hardware dealer for the NIOSH approved proper
mask.
LABELS ON TOOL
The label on your tool may include the following symbols
along with date code:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear ear protection.
Wear safety glasses or goggles.
V Volts
A Amperes n
Hz Hertz
W Watts
min minutes
Alternating
/min.
Current
Direct Current
No-Load Speed
0
Class II Construction
Earthing Terminal
Safety Alert Symbol
Revolutions or
Reciprocation per
minute