Connecting The Telephony Gateway - Arris Touchstone TG2472 User Manual

Connecting the Telephony Gateway

WARNING
Risk of injury or equipment damage
Connecting the Telephony Gateway to the home's existing telephone wiring should only be
performed by a professional installer. Physical connections to the previous telephone provider must
be removed and the wiring must be checked; there must not be any voltage. Cancelation of
telephone service is not adequate. Failure to do so may result in loss of service and/or permanent
damage to the Telephony Gateway.
1. Connect one end of the coax cable to the cable outlet or splitter, and the other end to
the Telephony Gateway's Cable connector (6). Tighten the connections by hand, then
tighten an additional 1/8 turn with a wrench.
Note: For best performance, use high-quality coax cable and minimize or eliminate
splitters between the cable jack and the Telephony Gateway. If you are using MoCA for your
home network, MoCA filters must be installed on any legacy client devices. Your cable company
will install these filters for you.
2. Insert the plug from the power cord into the Power connector on the back of the
Telephony Gateway (7) and insert the power cord into a convenient AC outlet.
The Power light on the front of the Telephony Gateway lights up, then flashes once
(refer to the LED tables shown in Using the Telephony Gateway). See
(page 38) if the Power light does not turn on.
Release 24 STANDARD 1.1 January 2015
Chapter 5: Installing and Connecting your Telephony Gateway
Touchstone TG2472 Telephony Gateway User Guide 25
Troubleshooting