Pioneer AVG-VDP1 Installation Manual page 14

Installation
When installing the antenna inside the vehicle (on the rear shelf)
Affix the metal sheet on as level a surface as possible where the GPS antenna faces the
window. Place the GPS antenna on the metal sheet. (The GPS antenna is fastened with its
magnet.)
Note:
• When attaching the metal sheet, do not cut it into small pieces.
• Some models use window glass that does not allow signals from GPS satellites to pass through. On
such models, install the GPS antenna on the outside of the vehicle.
13
GPS antenna
Metal sheet
Peel off the protective sheet.
Clamps
Use clamps to secure the
lead where necessary inside
the vehicle.
Make sure the surface is free of
moisture, dust, grime, oil, etc.,
before affixing the metal sheet.
Note:
• The metal sheet contains a
strong adhesive which may
leave a mark on the surface
if it is removed.