Glossary; Accessories; Assembly; Contents Of Carton - Craftsman 919.166700 Operator's Manual

Become familiar with these terms before operating
the unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of
measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of
measure of pressure.
ASME: American Society of Mechanical Engineers;
made, tested, inspected and registered to meet the
standards of the ASME.
Code Certification: Products that bear one or
more of the following marks: UL, CUL, ETL, CETL,
have been evaluated by OSHA certified independent
safety laboratories and meet the applicable
Underwriters Laboratories Standards for Safety.
This unit is capable of powering the following Accessories. The accessories are available through the current
Power and Hand Tool Catalog or full-line Sears stores.

Accessories

• In Line Filter
• Tire Air Chuck
• Quick Connector Sets
(various sizes)
• Air Pressure Regulators
• Oil Fog Lubricators
• Air Hose:
1/4", 5/16", or 3/8" OR
1/2" I.D. in various
lengths

Contents of Carton

1 - Air Compressor
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Rubber Bumpers
2 - Screws, 1/4-20 x .75
1 - Quick Connect
1 - Safety Check Valve

GLOSSARY

Cut-In Pressure: While the motor is off, air tank
pressure drops as you continue to use your acces-
sory. When the tank pressure drops to the factory
set low pressure the motor will restart automatically.
The low pressure at which the motor automatically
restarts is called "cut-in" pressure.
Cut-Out Pressure: When an air compressor is
turned on and begins to run, air pressure in the air
tank begins to build. It builds to a factory set high
pressure before the motor automatically shuts off -
protecting your air tank from pressure higher than
its capacity. The high pressure at which the motor
shuts off is called "cut-out" pressure.
Branch Circuit: Circuit carrying electricity from
electrical panel to outlet.
ACCESSORIES

ASSEMBLY

Tools Required for Assembly

1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
7 - ENG D23012