Epson TM-L90 User Manual page 13

Cleaning the Platen Roller/Roll Paper End Sensor
When paper dust accumulates on the platen roller or the roll paper end sensor,
follow the steps below to clean them. To maintain good functional capabilities,
clean them regularly (every 6 months).
1. Turn off the printer, open the peeler cover, and then the roll paper cover.
2. Clean the platen roller and roll paper end sensor with a cotton swab lightly
moistened with water or an alcohol, as shown in the illustration.
.
3. Close the roll paper cover after the water or alcohol has dried.
Cleaning the Peeler Unit
After the peeler is used for a prolonged period of time, the glue from the labels
accumulates on the rollers of the peeler unit. If you leave the rollers in such a
condition, the glue may stick to issued labels, or a paper jam may occur. To
prevent malfunctions and maintain good print quality, clean the rollers regularly
(every 100,000 labels).
You can clean them easily if you use a wasted label, as shown in the illustration.
Note:
Do not use any alcohol based solvents for cleaning. Such solvents may enter the roller shaft
and cause a malfunction of the peeler.
TM-L90 with Peeler User's Manual 9
English