CUC 2058 D / 2059 D
PICTURE
Contrast
Sharpness
PICTURE
Contrast
Sharpness
Tint
24
SOUND
TV
Effects
A 01
y y
OK
SOUND
TV
Effects
A 01
y y
OK
GRUNDIG Service
SETTINGS
____________________________________________________________________________________
Picture settings
Adjusting the contrast and sharpness
1
Call up the » PICTURE« menu with »
– The »PICTURE« menu appears.
2
Select the desired function (»Contrast« or »Sharpness«) with
– _ – _ – _
– _ – _ – _
».
«.
.
TXT
3
Adjust the contrast or sharpness with
Note:
The TV set has been tested using maximum contrast, in order to check for
reliability of all modules. Depending on the location of the set and the
brightness in the room (surrounding light) it does however make sense to
reduce the contrast slightly for the best possible picture impression.
The sharpness adjustment is not needed for digital services, i.e. the row
»Sharpness« is not available in digital mode.
4
End the setting with » TXT«.
Adjusting the tint for NTSC broadcasts
Note:
The » Tint« row appears only with NTSC broadcasts.
1
Call up the » PICTURE« menu with »
– The »PICTURE« menu appears.
– _ – _ – _
– _ – _ – _
– _ – _ – _
2
Select the » Tint« row with
TXT
3
Adjust the tint with
4
End the setting with » TXT«.
SETTINGS
____________________________________________________________________________________
Sound settings
Stereo/two-channel sound, mono
If the TV set receives two-channel sound transmissions – e.g. a film in the origi-
nal language on sound channel B (display: » DUAL B «) and the synchronized
version on sound channel A (display: » DUAL A «) – then you may select the
desired sound channel.
If the set receives stereo or NICAM transmissions, it automatically switches to
stereo sound (display: »Stereo«). If stereo reception is poor, then the sound
should be switched to » Mono «.
1
Call up the »SOUND« menu with »
2
Select the »
L/R
Dolby Pro Logic
then select the desired sound mode with
Stereo
Stereo
3
If the sound for a particular channel is to be permanently in mono, select the
»
P..« row with
TXT
Note:
To cancel this setting, repeat step 3.
4
End the setting with » TXT«.
Adjusting the bass and treble
L/R
Dolby Pro Logic
1
Call up the »SOUND« menu with »
Stereo
Stereo
2
Select the desired row (»
TXT
3
Adjust the bass or treble with
4
End the setting with » TXT«.
– The setting is saved automatically.
«
.
z
»F
« or
»E
«, respectively.
F
E
«
.
z
»,
,
« or
».
.
«.
»F
F
« or
»E
E
«.
«.
F F
A 01« (A = analogue TV channel) row with
»F
F
« or
»E
E
« .
»,
« or
».
« then press »OK«.
,
.
«.
F F
« – bass, or » « – treble) with
»F
« or
»E
«, respectively.
F
E
Allgemeiner Teil / General Section
»,
,
« or
»,
« or
».
«
,
.
»,
« or
».
«.
,
.
25
1 - 15