Tool Specifications - Stanley FatMax FMFP12758 Operation And Maintenance Manual

FMFP12758_9R202313RA_FM_2N1 FLOORING TOOL_MAN_CC:FMFP12758_9R202313RA_FM_2N1 FLOORING TOOL_MAN_
OPERATION
Always handle the tool with care: 1.) Never engage in horseplay; 2.) Never pull the trigger
unless nose is directed toward the work; 3.) Keep others a safe distance from the tool
while tool is in operation as accidental actuation may occur, possibly causing injury.
The operator must not hold the trigger pulled on contact arm tools except during
fastening operation as serious injury could result if the trip accidentally contacted
someone or something, causing the tool to cycle.
Keep hands and body away from the discharge area of the tool. A contact arm tool may
bounce from the recoil of driving a fastener and an unwanted second fastener may be
driven possibly causing injury.
Check operation of the contact arm mechanism frequently. Do not use the tool if the
arm is not working correctly as accidental driving of a fastener may result. Do not
interfere with the proper operation of the contact arm mechanism.
Do not drive fasteners on top of other fasteners or with the tool at an overly steep angle
as this may cause deflection of fasteners which could cause injury.
Do not drive fasteners close to the edge of the work piece as the wood may split,
allowing the fastener to be deflected possibly causing injury.
This nailer produces SPARKS during operation. NEVER use the nailer near flammable
substances, gases or vapors including lacquer, paint, benzine, thinner, gasoline, adhesives,
mastics, glues or any other material that is -- or the vapors, fumes or byproducts of which are
-- flammable, combustible or explosive. Using the nailer in any such environment could cause
an EXPLOSION resulting in personal injury or death to user and bystanders.
MAINTAINING THE TOOL
When working on air tools note the warnings in this manual and use extra care when
evaluating problem tools.
FMFP12758 TOOL SPECIFICATIONS
All dimentions in inches unless otherwise specified
MODEL LENGTH
FMFP12758 20.35" (517 mm)
FASTENER SPECIFICATIONS:
MODEL
FMFP12758
FMFP12758
TOOL AIR FITTING:
This tool uses a 1/4" N.P.T. male plug. The inside diameter should be .200" (5mm) or larger. The fitting must
be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm²). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The FMFP12758 requires 3.7 cubic feet per minute (105 liters per minute) of free air to operate at the
rate of 60 fasteners per minute, at 80 p.s.i. (5.6 kg/cm²). Take the actual rate at which the tool will be run to
determine the amount of air required. For instance, if your fastener usage averages 30 fasteners per minute,
you need 50% of the tool's c.f.m. of free air which is required to operate the tool at 60 fasteners per minute.
HEIGHT WIDTH
22.08" (561 mm) 3.15" (80 mm)
FASTENER CROWN WIDTH
BCS15xx 1/2" (13mm)
FLN-xxx -
WEIGHT
10.85 lbs (4.9 kg)
GAUGE FASTENER RANGE
15-1/2 Ga., 1/2" 1-1/2" (38mm) to
Crown Staples 2" (50mm)
16 Ga. "L" shape 1-1/2" (38mm) to
Cleat Nails 2" (50mm)
-4-