Wireless Network - Samsung BD-D5300 User Manual

Wireless Network

You can connect to network with a Wireless IP sharer (a router or a modem).
1. A wireless AP/IP router and the Samsung Wireless LAN Adapter is required to make a wireless
network connection. Connect the Wireless LAN adapter (not included) to the Wireless LAN Adapter
jack on the rear panel of the player. See the diagram below.
2. To Set the network options. See pages
Broadband
service
Networking with PC
for AllShare function
✎
NOTE
▪
Use only the Samsung wireless LAN adapter with this player. (Model name : WIS09ABGN
Do not use this wireless adapter with any third-party players.
To purchase the Samsung wireless LAN adapter, visit your Samsung retailer.
▪
You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the
wireless network.)
▪
Wireless LAN, by its nature, may cause interference, depending on the
obstacles, interference by other radio devices, etc).
▪
Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.
▪
The player supports only the following wireless security key protocols :
WEP (OPEN/SHARED), WPA-PSK (TKIP/AES), WPA2-PSK (TKIP/AES)
▪
Due to changes in WiFi policy, this player cannot support the TKIP encryption method in the 802.11n mode
▪
To use the AllShare function, you must connect your PC to your network as shown in the figure. The connection can be
wired or wireless.
31~35.
Wireless IP sharer
Wireless LAN Adapter
(not included)
).
operating conditions (AP performance, distance,
.
23
English