(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
When inserting the Roll Pin D4 x 36 [79] into Nail Feeder (B) [80], be careful that the end of the Roll Pin
D4 x 36 [79] is not stick out from Nail Feeder (B) [80]. Insert the Feeder Spring [83] between the protrusion of
Nail Feeder (A) [78] and the protrusion of Nail Feeder (B) [80].
Nail Feeder (A) [78]
(3) Disassembly and reassembly of the cap (See Fig. 25.)
[Tool required]
Hex. bar wrench (4 mm)
(a) Disassembly
Remove the three Hex. Socket Hd. Bolts M5 x 16 [41], then the Cap [40] and Gasket (B) [39] can be
removed.
(b) Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse.
Protrusion
Roll Pin D4 x 36 [79]
Fig. 25
Gasket (B) [39]
Body Ass'y [24]
Fig. 26
--- 32 ---
Nail Feeder Ass'y [87]
Nail Feeder (B) [80]
Feeder Spring [83]
Protrusion
Hex. Socket Hd. Bolt
M5 x 16 [41]
Cap [40]