Chevrolet Equinox Fuel Cell Owner's Manual page 223

9. Inflate the tire up to the recommended inflation
pressure using the air pressure gage (E) on the
top of the unit. See Inflation - Tire Pressure
on page 5-19.
The pressure gage reading is slightly high while the
compressor is on. Turn the compressor off to get
an accurate reading. The compressor may be turned
on and off until the correct pressure is reached.
10. Turn off the air compressor by pushing the On/Off
switch to the O (off) position.
Be careful while handling the tire sealant and
compressor kit as they could be hot after usage.
11. Unplug the air compressor accessory plug (C) from
the accessory power outlet in the vehicle.
12. Disconnect the air only hose (F) from the tire valve
stem, by pulling the lever up and hose up.
13. Wrap the air only hose (F) around the side of the
air compressor channel to stow it back in its
original location.
14. Stow the air compressor accessory plug (C) back in
the air compressor. To do this, wrap the air
compressor accessory plug, snap in the plug, and
then push in the bottom and then the top of the
wrapped air compressor accessory plug.
CAUTION:
{
Storing the tire sealant and compressor kit or
other equipment in the passenger
compartment of the vehicle could cause injury.
In a sudden stop or collision, loose equipment
could strike someone. Store the tire sealant
and compressor kit in its original location.
15. Return the equipment to its original storage location
of your vehicle.
5-43