KitchenAid W10271686B Installation Instructions Manual page 17

4. Using a T15 Torx ® screwdriver, remove the burner base.
A
B
C
D
A
B
C
D
A
B
C
D
5. Apply masking tape to the end of a
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into gas opening and press down onto the
gas orifice spud and remove by turning the gas orifice spud
counterclockwise and lifting out. Set gas orifice spud aside.
6. Replace with correct Natural gas orifice spud. See the
"Natural Gas Orifice Spud/Hood Chart."
Use the following chart to find the exact orifice spud
placement.
Natural Gas Orifice Spud/Hood Chart
Burner Rating Size
5,000 BTU 1.01 mm
15,000 BTU 1.75 mm
20,000 BTU 1.89 mm
0.69 mm
18,000 BTU 1.93 mm
Burner orifice spud
A
A. Size stamp
7. Place LP gas orifice spuds in plastic parts bag for future use
and keep with package containing literature.
Large Dual Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Medium Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
Small Burner
A. Burner cap
B. Burner head
C. Gas opening
D. Burner base
mm nut driver to help
Burner Style
Small burners
Medium burners
Large burner - main
Large burner - simmer
Grill burner
Grill orifice hood
A
A. Size stamp
8. For medium and large burners, replace the burner base using
both screws. Replace burner head and cap.
For small burners, replace igniter using the following
instructions.
Replace Igniter - Small Surface Burners Only
1. Unplug igniter wire from electrode.
IMPORTANT: Do not let the igniter wire fall down under the
cooktop surface.
2. Using needle-nose pliers, remove the retaining clip and
spring from the igniter.
A
C
A. Retaining clip
B. Spring
C. LP gas igniter
3. Remove LP gas igniter and spacer from the burner base.
4. Insert Natural gas igniter into burner base. Slide spring onto
the underside of the igniter and lock into place with the
retaining clip.
A
C
A. Retaining clip
B. Spring
C. Natural gas igniter
5. Place LP gas igniter, spacer, spring, and clip in plastic parts
bag for future use and keep with package containing
literature.
6. Plug in igniter wire.
7. Replace the burner base using both screws.
8. Replace burner head and cap.
B
B
17