Crossover Mode; Stereo Bypass Mode; Get Started - Crown XLS 1000 Operation Manual

Xls series

Hide thumbs Also See for XLS 1000:

Operation manual (38 pages)

Specifications (2 pages)

Table Of Contents

Table of Contents

Get Started

Stereo Bypass Mode

This is the default mode the ampliﬁ er is set to from the factory. The ampliﬁ er is

conﬁ gured for stereo mode with the PureBand™ Crossover System Bypassed.

1. Connect Left/Right signal source to Channel 1 and Channel 2 using either

the XLR, ¼ Inch, or RCA connectors.

2. Connect a speaker to each channel output using Speakon

or bare wire.

Bridge-Mono Mode

Bridge-Mono Mode delivers the power of both amp channels into a single 8 or

4 ohm load.

Before you get started ensure that you:

1. Connect signal source to Channel 1 only using either the XLR, ¼ Inch, or

RCA connectors.

2. Connect the speaker as shown.

a. If using the binding post outputs, connect the positive terminal of the

speaker to the positive terminal of Channel 1 and the negative terminal of

the speaker to the positive terminal of Channel 2.

b. If using a Speakon

connector, connect the positive terminal of the speaker to 1+ and the negative terminal to 2+.

Plug the connector into the Channel 1 output only.

Follow these quick steps to conﬁ gure the ampliﬁ er for "Bridge Mode":

1. Hold the "Mode/Menu" button down for 3 sec until the LCD screen displays "Amp Mode <More>".

2. Press the "Mode/Menu" button to begin conﬁ guring the Amp Mode.

3. Press the "Next" button until the LCD screen reads "Mode: Bridge".

4. Press the "Mode/Menu" button to conﬁ rm your selection.

5. Now press the "Next" button until the LCD screen displays "Bypass". Press the "Mode/Menu" button to conﬁ rm your selection. The LCD screen should now read

"Bridge Bypass".

Crossover Mode

When using the "Crossover Mode", the ampliﬁ er is conﬁ gured to use a LowPass

Filter on Channel 1 and a HighPass Filter on Channel 2.

Before you get started ensure that you:

1. Connect signal source to Channel 1 only using either the XLR, ¼ Inch, or

RCA connectors.

2. Connect a speaker to each channel output using Speakon

or bare wire.

Follow these quick steps to conﬁ gure the ampliﬁ er for "Crossover Mode":

1. Hold the "Mode/Menu" button down for 3 sec until the LCD screen displays

"Amp Mode <More>".

2. Press the "Mode/Menu" button to begin conﬁ guring the Amp Mode.

3. Press the "Next" button until the LCD screen displays "Input Y". Now press the "Mode/Menu" button to conﬁ rm.

4. Now press the "Next" button until the LCD screen displays "XOVER" and press the "Mode/Menu" button to conﬁ rm.

5. Now use the "Previous" or "Next" button to select your desired crossover point.

6. Once you have selected your crossover point, press the "Mode/Menu" button to conﬁ rm your selection. The LCD screen should now read "Input Y XOVER".

page 4

, Banana Plugs,

XLS Series Power Ampliﬁ ers

Operation Manual

Table of Contents