Invacare Bora Service Manual page 113

®
Invacare - Bora/Spectra XTR
·
Remove the backrest cushion.
·
Loosen the straps of the sling backrest or remove the Flex3 backrest.
·
Loosen and remove both screws (5) of the actuator fixation bracket.
·
Remove the cover of the actuator fixation bracket.
·
Loosen and remove the screws and nuts (2, 4) on the upper and lower actuator fixation
bracket on both sides.
·
Adjust the backrest fixation (6) for the new backrest width according to the table on page 112.
·
Insert the screws (2) through the cover of the actuator fixation bracket and the corresponding
holes of the backrest fixation to the actuator fixation.
·
Fasten these with the nuts (4).
·
Reposition the cover of the actuator fixation bracket.
·
Insert and tighten the screws (5) again.
·
Adjust the straps of the sling backrest to the new width or install the adjusted Flex 3 backrest.
·
Install the backrest cushion.
·
Perform a function check of the chair
SERVICE MANUAL
113