After the system passes self-test, you must verify proper system operation.
First verify the presence of UltraSCSI devices; then verify the boot device load
path. After the path is verified, you can boot the operating system and use
operating system-based test programs (such as VET) to complete system
verification.
The system is tested automatically during power-up; no off-line loadable
diagnostics are required or provided. The Loadable Firmware Update (LFU)
Utility is currently the only supported off-line loadable program. It is used to
update firmware on any module residing on the system that has updatable
firmware.
Sections in this chapter include:
•
Console Load Device
•
Verification Overview
•
Diagnostics Overview
•
Run System Self-Test
•
Show Commands for Installation
•
Verify SCSI Devices
•
If Necessary, Run the RAID Configuration Utility
•
Booting Factory Installed Software
•
Booting OpenVMS from a CD-ROM
•
Booting Tru64 UNIX from a CD-ROM
•
Set Commands for Booting
•
Booting LFU from a CD-ROM
•
Running the System Exerciser VET
Diagnostics and Utilities
Diagnostics and Utilities
Chapter 8
8-1